Commercial Door Repair

Commercial Door Repair Washington DC

Is your commercial door dragging on the floor, slamming shut, or failing to latch? The cause is often the hinges, closer, frame, or strike rather than the lock, because every part of a commercial entrance works together.

DC Locks & Doors handles commercial door repair for storefront, office, and multi-tenant entrances throughout Washington, DC. We find the part that's actually failing before replacing anything. Door won't secure right now? See emergency commercial door repair.

Need Door Repair Service?

Call (202) 919-5727 or request door repair online. Open daily, 7 AM–11 PM.

Detex exit alarm with keys on a gray steel rooftop door

Common Door Problems and Likely Fixes

Most commercial door problems show up in a few predictable ways. Here is what each symptom usually points to. We confirm the cause on site.

Commercial Door Services

Most commercial door failures come down to hardware or alignment, not the door slab itself. Choose the service that matches your door:


If the lock itself has failed, see commercial lock repair. To move away from physical keys, see access control systems.

Door Alignment and Frame Repair

Building settling, worn hinges, and daily traffic can pull a door out of line with its frame and strike, so it binds, drags, or won't latch. We tighten or replace hinge fasteners, adjust or replace hinges and pivots, reset the strike, and correct minor frame problems so the door and lock line up again.

Door Closers

A closer that slams, drifts, or stops short keeps the door from latching, even when the lock is fine. We adjust, repair, and replace surface, concealed, and floor closers. Details are on our door closer repair page.

Panic Bars and Exit Devices

Exit devices wear from constant use and can stop catching the strike. We adjust, repair, and replace them, and check the door and closer at the same time. See panic bar repair for device types and repair options.

Hinges, Pulls, Plates, and Weatherstripping

One visit can cover the hardware that keeps a door hanging straight and sealing well: SELECT continuous hinges and Hager, McKinney, Stanley, and Ives hinges; Rockwood pulls, push plates, and kick plates; Don-Jo wrap-around plates; and NGP door sweeps, thresholds, and weatherstripping. On automatic entrances we replace BEA sensors; see ADA automatic door openers.

What Happens During the Appointment

We watch the door open, close, and latch to see where it fails. Then we check the hinges, closer, frame, strike, and lock together, since one worn part often causes problems elsewhere.

We explain what we found and your options, along with the price, before starting. After the repair, we cycle the door several times to confirm it closes, latches, and locks.

Repair or Replace?

Repair or adjust first when the door and frame are structurally sound. Replacement makes more sense when a frame is bent or split badly enough that the door can't be realigned, when the door itself is warped, rusted through, or coming apart, or when hardware is cracked or no longer supported. Minor frame damage can often be repaired. We tell you which applies before any work starts.

If the door or frame needs to go, see door replacement.

What Affects the Cost

Commercial door repair pricing depends on what is failing and what it takes to fix it:

What to Send Us Before the Visit

These details help us diagnose the door and bring the right parts:

Frequently Asked Questions

Q: Should a commercial door be repaired or replaced?
A: If the door and frame are structurally sound, repair is usually the right call: alignment, hinges, closers, and hardware can typically be fixed without a new door. Replacement makes more sense when the frame is bent or split so the door can’t be realigned, or the door itself is warped or deteriorated. We explain which applies before recommending anything.
A: Common causes are a misaligned frame or strike, worn hinges, a failing closer, or building settling. The lock itself is often fine, so we diagnose the cause before replacing hardware.
A: Dragging usually means the door has sagged on worn hinges or loose hinge screws. Tightening, replacing hinges, or adding a continuous hinge on a heavy door often fixes it.
A: Yes. We work on aluminum storefront doors and their hardware, including closers, exit devices, and locks.
A: Yes. If the door is out of alignment, the latch and strike may not line up, so the door is hard to lock even though the lock works.
A: Yes. We can coordinate repairs across several doors or properties and schedule around building access hours.

Need Commercial Door Repair in Washington, DC?

Call DC Locks & Doors at (202) 919-5727. Open daily, 7 AM–11 PM.

DC Locks & Doors logo

Working Hours